Home Technology Pulse Plugs Direct Hits The Edge FAQ Hall Of Fame Testimonials Installation Other Products Shop Contact Us


DirectHits mounts on your current spark plugs. Immediately, the technological advances of 'DirectHits' are evident. DirectHits feature a unique capacitor-based circuit that captures energy normally wasted by spark plugs and generates a spark with 20,000 times greater energy than any spark plug. Whether you're using your two stroke engine in an outboard motor, motorcycle, personal watercraft, snowmobile or ultralight, DirectHits will give you more power on less fuel - guaranteed!

For engines which require a colder heat range plug or for engines that use plugs of a different size than Pulstar plugs, use DirectHits.


(77MB download)


Direct Hits Installation Instructions

Thanks for choosing Direct Hits. Direct Hits turn regular spark plugs into super spark plugs with a spark many times greater than a standard plug.

Direct Hits come with a lifetime warranty from the factory. No need to replace them. Below are the standard installation instructions. It's quite easy and you will be up and running in minutes. If you encounter any problems please feel free to call. 505.977.6376

These are the basic parts for an installation. A non-resistor plug, the Direct Hits and the new spark plug cap.

Remove your existing spark plug cap from the wire.

Slide the weatherproof boot onto the spark plug wire. NOTE: Solid rubber caps need no boots

Screw the cap into the wire. There is a threaded stud inside the cap. Slide the boot on.

Remove the nut from the top of the plug if it came with one. Gap to engine mfg. specs.

Install the plug(s) and torque to the mfg. specs. Put a dot of blue Loctite on the top couple of threads.

Screw the Direct Hits onto the spark plug. Hand tighten only!! Do not use a tool to tighten the Direct Hits

Snap the new cap on the Direct Hits.



Download these instructions.







Fire in the Hole Distributors    PO Box 53025  Albuquerque, NM 87153    505.977.6376